Assembly Guides

This guide walks you through the procedures of folding the Positron V3.2.

This guide contains instructions for putting all the parts together.

This guide contains instructions for building the base plate for the Positron V3.2.

This guide contains instructions for building the spool holder for the Positron V3.2.

This guide contains instructions for building the toolhead for the Positron V3.2.

This guide contains instructions for building the touch panel for the Positron V3.2.

This guide contains instructions for building the bed V holder for the Positron V3.2.

This guide contains instructions for building the Z drive for the Positron V3.2.

In this guide we will build the Z column for the Positron V3.2.

This guide walks your through the assembly of the bowden extruder for the Positron V3.2. We also recommend you checking wiki.positron3d.com during the whole build as there are many helpful information.

This guide will walk you through common firmware configurations for your 3D printers. Leviathan boards ship out already flashed with USB firmware. Run ls /dev/serial/by-id/* to confirn you have a klipper ID. If you need to update firmware or use other ways of connection, there are two major steps covered in this guide that will need to be completed in order: Flashing the Leviatan with the Katapult Bootloader The USB interface should be used for the Katapult bootloader for both USB or CAN Klipper configuration. The UART interface should be used for the Katapult bootloader for UART Klipper configuration. Flashing the Leviatan with the Klipper Firmware USB interface is the recommended configuration for most situations. CAN interface is supported, if you are using CANBus UART interface can be used when USB ports aren't available such as with Raspberry Pi Zero 2W. This are the recommended configurations however Leviathan is very flexible, so not all options are covered by this guide. Important Links: Leviathan GitHub Repo - https://github.com/MotorDynamicsLab/Leviathan

This guide will walk you through common firmware configurations for your 3D printers. There are two major steps covered in this guide that will need to be completed in order: Flashing the Leviatan with the Katapult Bootloader The USB interface should be used for the Katapult bootloader for both USB or CAN Klipper configuration. The UART interface should be used for the Katapult bootloader for UART Klipper configuration. Flashing the Leviatan with the Klipper Firmware USB interface is the recommended configuration for most situations. CAN interface is supported, if you are using CANBus UART interface can be used when USB ports aren't available such as with Raspberry Pi Zero 2W. This are the recommended configurations however Leviathan is very flexible, so not all options are covered by this guide. Important Links: Leviathan GitHub Repo - https://github.com/MotorDynamicsLab/Leviathan